11
Upgrade
Guide
8. Undo
Press this button to return to the state prior to executing
the Cut, Copy, or Paste commands. This can be used only
to return to the immediately previous state. If the button
indicates Redo, you can use it to cancel the Undo.
The data is held in common with the “7. Undo” data of “3c-2.
Automation.” If you press the Automation Undo button
immediately after event-editing, the last event-edit will be un-
done - not the automation recording.
9. Select List
Press this button to open the Select List dialog box. Here
you can select the channel and parameter that will be dis-
played in the event list. You can select one (and only one)
of channels 1-16, MasterFader, or Expression.
If D32XD data containing Aux 3 and 4 events is loaded into
the D16XD, disabling all selections here will let you view
only Aux 3 and 4 events. Then you can use “5. Cut” with
Select All, and delete all of the Aux 3 and 4 events in a single
operation.
3c-4. Edit Scene
The mixer settings you adjust can be stored as a “scene” at a
desired location, and automatically recalled during playback
to change the mixer settings (when the “3c-2. Automation”
setting “Automation” is on). You can also recall a scene when
desired as a set of general-purpose settings . You can store
one hundred scenes for each song.
Refer to 3c-2. Edit Scene (→Manual: p.108).
4. Automation button has been moved to “Automation” in
“3c-2. Automation” (p.9) of this document.
3c-5. Scene Filter
Refer to 3c-3. Scene Filter (→Manual: p.109).
3c-6. Mixer View
Refer to 3c-4. Mixer View (→Manual: p.109).
To Next Page
Loading...
Need help?
General
