Korg DS-DAC-10R - macOS DSD Native Playback (Core Audio)

12
DSD native playback via Mac (Core Audio)
1
Use the AudioGate and USB Audio Device Setup program to install AudioGate (refer
to “Installing the AudioGate” on page 6).
2
Connect the DS-DAC-10R to your computer, and then start AudioGate.
If you start AudioGate without the DS-DAC-10 Rconnected, license verication will be
completed when you connect the DS-DAC-10R.
3
From the menu, choose Mac, [AudioGate]-[Preferences...], and click the [Audio Devices]
tab.
4
In [Driver Type], make sure that “Core Audio” is selected.
5
Choose “KORG 2ch 1bit Audio Device” for both the [Output Device Name] and [Input
Device Name]. Playback is not aected even if you leave [Input Device Name] blank.
6
Set [Sample Rate] to “Auto” or to “5.6 MHz” or “2.8 MHz.”