4
• ASIO driver installation procedure
Do not connect the DS-DAC-10R to your computer before you’ve nished installing
the driver. If you’ve already connected it, disconnect it; then reconnect it after you’ve
nished installing the driver.
The installation screens shown on your computer may differ somewhat depending on
your Windows version and system, but the procedure is the same. The explanation that
follows will show typical screens in Windows 7.
If, during installation, a message appeared to conrm whether or not to continue the in-
stallation, click [Install].
1
In the KORG AudioGate and USB Audio Device Setup panel that you downloaded,
click “Install DS-DAC-10R Driver” to start the installer.
2
In the language selection menu, choose English; click [OK].
3
The dialog box will appear; click [Next >].
4
If you accept the license agreement, click [Next (N) >].
To Next Page
Loading...
