En-4
CABLE CHECK jack
Connect one end of a standard mono instrument cable to the INPUT1 jack and the other end to the
CABLE CHECK jack.
NOTE:
Noise may occur if a cable is connected to the CABLE CHECK jack aer a cable was connected
to the INPUT1 jack.
DC 9 V jack
Connect the included AC adapter to this jack.
Never use any AC adapter other than the one that’s included. is may cause a malfunction.
Fasten the AC adapter’s power cord in place by hooking it on the cord hook to prevent the included
AC adapter’s plug from being disconnected from the terminal.
Cord hook
To Next Page
Loading...
