Korg Pitchblack X Pro - Rear Panel and Other Jacks; Connections and Cabling; Input and Output Jacks

En-3
Connections
To effect pedals, amps or other equipment
Guitar, bass, etc.
Guitar, bass, etc.
To effect pedals, amps or other equipment
AC adapter (included)
To AC outlet
INPUT 2
DC 9V
OUTPUT2
INPUT 1OUTPUT1
Turn o the power to all devices before you connect an instrument to avoid damaging your equip-
ment.
e INPUT1, INPUT2, OUTPUT1, OUTPUT2 and CABLE CHECK jacks are for mono signals
only. Stereo (TRS) cables will not work.
INPUT1 jack
Connect a cable from the INPUT1 jack to the instrument to be tuned.
INPUT2 jack
Connect a cable from the INPUT2 jack to the instrument to be tuned. If a cable is connected to the
INPUT1 jack on the front panel, this jack will be disabled and cannot be used.
OUTPUT1, 2 jacks
Connect a cable from the OUTPUT jack to your eect pedals, amp, etc.
e signals that are input from either the INPUT1 or the INPUT2 jack pass through the buer and
are respectively sent to the OUTPUT1 and OUTPUT2 jacks.
Press the MUTE button to enable or disable the mute function for the signal that’s output from the
OUTPUT1 and OUTPUT2 jacks. When the mute function is enabled, the MUTE LED will light up,
and the signal will not be output from the OUTPUT1 and OUTPUT2 jacks.
NOTE:
When the tuner is in standby power mode, no signal is output from the OUTPUT1 and
OUTPUT2 jacks.