42
18. EQ — SYNTH/VOCODER
This is a two-band equalizer. Use EQ FREQ (knobs 1 and 3 to specify the frequency that you want to adjust, and use knobs 2 and 4 to adjust
the gain of each frequency band.
Excessively raising the equalizer gain parameters may cause the output to be distorted.
LOW EQ FREQ. [40Hz...1.00kHz]
Sets the frequency of the low-range
equalizer.
LOW EQ GAIN [-12...12]
Sets the amount of boost or cut for
the low-range equalizer.
HI EQ FREQ.[1.00kHz...18.0kHz]
Sets the frequency of the high-range
equalizer.
HI EQ GAIN [-12...12]
Sets the amount of boost or cut for
equalizer.
To Next Page
Loading...
Need help?
General
