5
Introduction
Front and rear panel
Front and rear panel
Front panel
1. [SW1] key, [SW2] key
These keys are on/off switches for the functions to
which they were assigned in Program, Combination,
Sequencer and Sampling modes (if the EXB-SMPL
option is installed). When on, the key will light
(
☞p.24).
2. Joystick
This controls pitch or modulation, etc.
Move the joystick up/down or left/right (+Y, –Y,
–X, +X) to control (
☞p.24).
Various program parameters and effect parameters
will determine what is controlled by the joystick.
3. Headphone jack
A set of headphones with a (1/4") stereo phone plug
can be connected here.
The output from the L/MONO and R OUTPUT jacks
can be monitored in stereo through the headphones.
4. [VOLUME] slider
This adjusts the volume that is output from the OUT-
PUT jacks (L/MONO, R) and the headphone jack.
5. REALTIME CONTROLS
Use the [SELECT] key to select realtime controller
mode A/B/C, and use knobs [1]–[4] to control the
tone, effects, MIDI control changes, and arpeggiator
etc. while you perform. (
☞p.25, 27)
[SELECT] key
This key switches the realtime controller between A-
mode, B-mode, and C-mode. The LED of the selected
mode will light.
[ARP ON/OFF] key
This key turns the arpeggiator on/off. When on, the
key will light.
[1], [2], [3], [4] knob
A-mode
[1] LPF CUTOFF:
Controls the cutoff frequency of the low pass filter.
[2] RESONANCE/HPF:
Controls the filter resonance level or the high pass filter
cutoff frequency.
1
3
4
7
9
10
13
12
2
5
68
11
To Next Page
Loading...
