Korg Wavedrum mini User Manual

Appendix
17
FrançaisDeutsch
EnglishVoice Name
Appendix
Restoring the factory settings
Here's how to return the WAVEDRUM Mini's
global settings and effect settings to their factory-set
condition.
1. While holding down the button, press the
power switch to turn on the power.
The display will blink “ PL ” and the button
indicator will blink.
2. Hold down the button for approximately two
seconds to execute the factory reset.
If you decide to cancel without executing, press
the power switch to turn off the power.
Never turn off the power while data is being
loaded. Doing so may damage the data.
3. When you execute this operation, the WAVE-
DRUM Mini will be returned to its factory-set
condition, and will be in the same state as after a
normal power-on.
Error messages
The WAVEDRUM Mini automatically performs an
internal check when its power is turned on. If a
problem is detected, one of the following error mes-
sages will be displayed. Take the appropriate action
described below.
E. 0 : The user data has been lost. Initialize the data
as described in “Restoring the factory settings”
above.
E. 1 : A system error has occurred. Immediately stop
using the WAVEDRUM Mini, and contact your
nearby Korg dealer.
Troubleshooting
If you suspect a malfunction, check the following
points first. If this does not resolve the problem,
contact your nearby Korg dealer.
Power won't turn on
• Make sure that the AC Adapter is correctly con-
nected to the WAVEDRUM Mini and to an AC
outlet.
• If you're using batteries, make sure that they are
inserted correctly.
No sound from the speaker
• Turn the VOLUME knob toward the right.
• No sound will be output from the speaker if a
cable is connected to the headphone jack or the
OUTPUT jack.
• Could the global parameter
G. 7 Speaker Level be
set to 0?
Can't select sounds or effects
Could the CLIP or PAD indicators of the buttons on
the left of the control panel be blinking?
Press one of the CLIP/PAD, , , or + buttons
to make the indicator change from blinking to
steadily lit.
Rhythm pattern doesn't sound
• Could the rhythm pattern / looper select indicator
(on the upper right side of the panel) be blinking?
If it's blinking, the rhythm pattern is muted. To
cancel muting, hold down the SHIFT button and
press the FX button.
• Could the global parameter
G. 6 rhythm pattern
level be set to 0?
Can't operate the buttons
The pattern number on the display will blink while
the rhythm pattern is being switched. During this
time, you won't be able to switch sounds or start/
stop the rhythm pattern.

Korg Wavedrum mini Specifications

General

Brand	Korg
Model	Wavedrum mini
Category	Synthesizer
Language	English