Kospel KDE Series User Manual

26
Temperature setting
Display shows three icons: You can set the desired temperature
value (which has been stored in memory for each icon) by pressing one of them
- the icons will be displayed in inverse .
To change the desired temperature value:
• push the icon,
• push the icon again and keep (for about 3 seconds) until the value starts to icker,
• to set the new value press ,
• to save the value press icon.
Notice: save the new value within 10 seconds, otherwise you will lose it.
Conguration
To enter the conguration mode press B . To adjust the value press The
parameters will switch as you press . You can switch between the following
parameters:
• maximum temperature value,
• display contrast (0-20),
• display brightness in stand-by-mode (0-20) /brightness min. / (0 – brightness max.),
• display brightness in active mode (0-20) /brightness max. / (brightness min. –20).
To exit parameters setting mode press Notice: parameters setting mode will
automatically exit after 20 seconds since the last adjustment.
Parameters view
To enter the parameters view mode press A .The parameters will switch as you press
. You can switch between the following parameters:
• ow rate ,
• percentage of maximum power with which the unit currently heats ,
• rated power ,
• correction of power ,
• software details and work time,
• inlet temp ,
• outlet temp .
To exit the parameters view mode press . Notice: parameters view mode will
automatically exit after 5 minutes since the last adjustment.

Kospel KDE Series Specifications

General

Brand	Kospel
Model	KDE Series
Category	Water Heater
Language	English