To Next Page

To Previous Page

GB-045BC_f.854

The heater switches on automatically straight after reaching the ow rate over

2,5l/min. The temperature control system adjusts the power rate according to the water

ow rate, required temperature and the water temperature in the mains.

There are two indicators on the case:

- green - power supply „on”,

- red - heating „on”.

Other modes are shown by ickering green light.

KDE, KDE2 Operation

Conguration

To enter the conguration mode press . To adjust the value press The

parameters will switch as you press

. You can switch between the following

parameters:

• maximum temperature value,

• display contrast (0-20),

• display brightness in stand-by-mode (0-20) /brightness min. / (0 – brightness max.),

• display brightness in active mode (0-20) /brightness max. / (brightness min. –20).

To exit parameters setting mode press Notice: parameters setting mode will

automatically exit after 20 seconds since the last adjustment.

Parameters view

To enter the parameters view mode press .The parameters will switch as you press

. You can switch between the following parameters:

• ow rate

• percentage of maximum power with which the unit currently heats

• rated power

• correction of power

• software details and work time,

• inlet temp ,

• outlet temp .

Kospel KDE2 Assembly And Operating Manual

Other manuals for Kospel KDE2