Kramer KDS-8 - Page 15

Kramer Electronics Ltd.
KDS-8 – Operating KDS-8
13
Defining Configuration OSD Duration
When you press the MENU button, the configuration OSD appears on the screen. If no other
buttons are pressed, it remains on the screen for a user-defined amount of time.
To define the amount of time the configuration OSD remains on the screen:
1. In the OSD, go to OSD > MENU TIMEOUT.
2. Set the timeout value in seconds.
The configuration OSD duration is defined.
Defining EDID
KDS-8 enables you to manually define the EDID source.
To define the EDID:
1. In the OSD, go to EDID > EDID SELECT.
2. Select the EDID from the following:
▪ Internal 1 – Internal 6
▪ External A
▪ User 1, User 2
The EDID source is defined.
Defining HDCP
KDS-8 enables you to define the HDCP status of the device.
To define the HDCP status of the device:
1. In the OSD, go to HDCP > HDMI HDCP.
2. Select one of the following options:
▪ Follow In – HDCP follows the input source device.
▪ Follow Out – HDCP follows the output acceptor display.
▪ Disable – HDCP is disabled.
HDCP status of the device is defined.
Changing Encoder/Decoder Mode – OSD
By default, KDS-8 is defined to operate in encoder mode. You can easily change the
encoder/decoder mode using the configuration OSD.
To change the encoder/decoder mode using front panel buttons, see Changing
Encoder/Decoder Mode – Front Panel on page 9.
To change the mode from encoder to decoder or vice versa:
1. In the OSD, go to DEVICE SETTINGS > STATUS.