Mounting KDS-8
This section provides instructions for mounting KDS-8. Before installing, verify that the
environment is within the recommended range:
• Operation temperature – 0 to 40C (32 to 104F).
• Storage temperature – -40 to +70C (-40 to +158F).
• Humidity – 10% to 90%, RHL non-condensing.
• KDS-8 must be placed upright in the correct horizontal position.
Caution:
• Mount KDS-8 before connecting any cables or power.
Warning:
• Ensure that the environment (e.g., maximum ambient temperature & air flow) is
compatible for the device.
• Avoid uneven mechanical loading.
• Appropriate consideration of equipment nameplate ratings should be used for avoiding
overloading of the circuits.
• Reliable earthing of rack-mounted equipment should be maintained.
You can install KDS-8 using one of the following methods:
• Mount to a flat surface using the attached mounting brackets.
• Place on a flat surface.
To Next Page
Loading...
