Kramer KDS-8 - Defining KDS-8 Sdvoe Streaming Transceiver

Kramer Electronics Ltd.
KDS-8 – Defining KDS-8 SDVoE Streaming Transceiver
4
Defining KDS-8 SDVoE Streaming
Transceiver
This section defines KDS-8.
Figure 1: KDS-8 SDVoE Streaming Transceiver
#
Feature
Function
POWER LED
Lights when the device is powered ON.
T/R LED
Encoder mode: Lights green.
Decoder mode: Lights amber.
SOURCE LED
Decoder mode: Lights when the HDMI input is live and selected.
LAN LED
Lights when the 1GbE LAN connection is active.
VIDEO LED
Encoder mode: Lights when HDMI input signal is detected.
Decoder mode:
• Genlock mode – Lights when streaming video is detected.
• FastSwitch mode – Lights constantly.
LINK Tx and Rx LEDs
Lights to indicate data transmission and reception activity over the
10GbE streaming connection.
OSD
Navigation
Buttons
MENU
Press to enter the configuration OSD menu, or to exit menu items.
+
When in OSD: Press to move up or
adjust selections.
When not in OSD:
• Press and hold both buttons
simultaneously for 10 seconds
to change the mode from
encoder to decoder or
decoder to encoder.
• Decoder mode: Press one of
the buttons to toggle the video
source between 10GbE (PoE)
and HDMI
TM
IN.
-
When in OSD: Press to move down
or adjust selections.
INFO/ENTER
When in OSD: Press to confirm a selection or to go deeper into a menu
item.
Not in a menu: Press to activate the information OSD.
HDMI OUT Connector
Encoder mode: Connect to a video acceptor for local viewing of the video
source connected to HDMI IN.
Decoder mode: Connect to a video acceptor for viewing the video
streamed from the encoder.
KDS-8 4K SDVoE Transceiver
POWER T/R SOURCE LAN VIDEO Tx Rx
LINK
MENU
-
+
INFO/ENTER
TM
1 2 3 4 5 6 7
138 169 10 1211 171514
Tx Rx G
AUDIO IR OUT IR IN
RS-232
SERVICE
1GbE LAN
10GbE (PoE)
HDMI OUT HDMI IN
TM TM