KT-208 / KT-208WM – Contents
Mounting the KT-208 / KT-208WM
The KT-208 package is for mounting the tablet on a table and the KT-208WM package is for
mounting the tablet on a wall.
Always be careful when attaching or removing the 8" Touch Panel from a mount.
Mounting KT-208 on a Table
Mount KT-208 on a table using one of the following options:
• Moveable Mount: Place the tabletop mount on the table. Connected cables remain visible
and the table remains intact.
• Secure Mount: Bolt the tabletop mount into the table. Connected cables are hidden through
a hole in the table.
Moveable Mount
1. Run any cables that connect to the KT-208 through the
center of the table stand (for example the Ethernet cable).
2. Connect the cables to the KT-208.
3. Lay the KT-208 face-down and mount the table stand on it.
4. Insert and fasten the provided M2.5 screw that secures the
bottom of the KT-208 to the table stand.
The table stand and tablet are now ready for use.
Secure Mount
• You may need to cut an opening in the table, if you need to pass cables from underneath.
1. Secure the stand to the table using the
two 5/32” screws provided.
To Next Page
Loading...
