Kramer RC-74DL User Manual

RC-74DL - Connecting the RC-74DL
11
To ground the RC-74DL:
1. Connect the Ring Tongue terminal to the building grounding point wire (it is
recommended to use a green-yellow AWG#18 (0.82mm
2
) wire, crimped with
a proper hand-tool).
2. Insert the M3x6 screw through the toothed lock washers and the tongue
terminal in the order shown above.
3. Insert the M3x6 screw (with the two toothed lock washers and ring tongue
terminal) into the grounding screw hole and tighten the screw.

Kramer RC-74DL Specifications

General

Brand	Kramer
Model	RC-74DL
Category	Controller
Language	English