Overview
3
3 Overview
The TP-573 and TP-574 are a twisted pair transmitter and receiver for
HDMI, bidirectional RS-232 and infrared signals. The TP-573 converts the
input signals to a twisted pair signal and the TP-574 converts it back to
HDMI, RS-232 and infrared signals.
Using the TP-573 and TP-574, you can pass via the twisted pair cable:
x EDID (Extended Display Information Data) and HDCP signals
between the TP-573 and TP-574, and vice versa between the TP-574
and TP-573
x HPD (Hot Plug Detect) signals from the display device to the source
The transmitter / receiver pair feature:
x A maximum data rate of 1.65Gbps
x Bidirectional RS-232 and IR interfaces. The IR input/output transmits
and receives IR commands over CAT 5 cable
1
x An RS-232 baud rate of up to 38400kbps
x HDTV compatibility
x A system range
2
of up to 90m (295ft) at 1080i, or up to 30m (98ft) at
1080p on shielded BC-DGKat524 cable; 90m (295ft) at 1080i, or up to
70m (230ft) at 1080p on shielded BC-DGKat623 cable; 100m (330ft) at
1080i or up to 90m (295ft) at 1080p on shielded BC-DGKat7a23 cable.
Note, use only shielded cables with the TP-573 / TP-574, in which the
cable Ground shielding must be connected / soldered to the shield of
both RJ-45 connectors
x Power save, the TP-573 / TP-574 system goes into standby mode when
the HDMI input is not connected
x The Power Connect System™ – a single connection to the transmitter
powers both units
x A compact DigiTOOLS
®
enclosure where three units can be rack mounted
side-by-side in a 1U rack space with the optional RK-3T rack adapter
1 Compatible with a Kramer transmitter and via a Kramer external remote receiver: C-A35M/IRR or C-A35M/IRE or
C-A35M/2IRE
2 Note that the transmission range depends on the signal resolution, graphics card and display used. The distance using non-
Kramer CAT 5, CAT 6 and CAT 7a cables may not reach these ranges
To Next Page
Loading...
