Kramer TP-580CT - Defining TP-580 CT 4 K USB Transmitter

Kramer Electronics Ltd.
TP-580CT – Defining TP-580CT 4K USB Transmitter
4
Defining TP-580CT 4K USB
Transmitter
This section defines TP-580CT.
Figure 1: TP-580CT 4K USB Transmitter Front Panel
#
Feature
Function
USB-C IN Connector
Connect to a USB-C AV source (that supports DisplayPort Alternate
Mode). Charges sources (that support USB Power Delivery 2.0) up to
60W.
While charging, the charging icon (to the right of the connector) becomes
visible and lights orange.
IN LED
Lights blue when a USB-C input device is connected.
OUT LED
Lights blue when an HDMI output device is detected on the receiver side.
LINK LED
Lights green when the HDBT connection is active.
ON LED
Lights green when receiving power.
HDBT OUT RJ-45
Connector
Connects to the HDBT IN RJ-45 connector on a receiver (for example, TP-
580R).
RS-232 3-pin Terminal
Block Connector
Connects to a PC/serial controller to control the remote controlled unit (for
example, the display on the receiver).
IR 3.5mm Mini Jack
Bidirectional IR connection. Outputs a received IR signal (from the HDBT
receiver) to connected IR emitter or transmits an IR signal (from IR sensor)
to the HDBT receiver.
SETUP DIP-Switches
Set DIP-switches. (see Setting the DIP-Switches on page 7).
20V DC
+20V DC 6A connector for powering the unit and charging the connected
input device.
1
2
3
4
5
6
7
8
9
10