TP-590RXR Quick Start (P/N: 2900-300860QS REV 2)
TP-590RXR Quick Start Guide
This guide helps you install and use your TP-590RXR for the first time.
Go to www.kramerav.com/downloads/TP-590RXR to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
TP-590RXR HDMI Line Receiver
Step 2: Get to know your TP-590RXR
Connect to the USB peripheral devices, (for example, USB camera, computer mouse, or
keyboard).
Lights green when power is received over the TP connection.
Lights green when the HDBT link is valid.
Lights green when the device receives power.
Connect to the HDBT OUT RJ-45 connector on the HDBT transmitter.
IR 3.5mm Mini Jack Connector
Connect to an external infrared transmitter or sensor.
RS-232 3-pin Terminal Block
Connect to an RS-232 device to be controlled, for example, a projector.
AUDIO OUT 3.5mm Mini Jack
Connector
Connect to the stereo, analog audio acceptor.
Connect to the HDMI acceptor.
Set the device behavior (see Step 4).
RS-232 3-pin
Terminal Block
Connect to the serial controller for this device.
Connect to the Ethernet controller to control this device or to a LAN to pass network traffic.
Press and hold for 5 seconds to reset the device to factory default settings.
Press and immediately release to power-cycle the device (Reset).
Connect to a PC to perform firmware upgrades.
Connect to the supplier power adapter if power is not supplied from a PoE device via the TP
cable.
To Next Page
Need help?
General
