VP-419xl - Controlling the VP-419xl
5.3 Using the Infra-Red Remote Control Transmitter
You can control the VP-419xl from the infra-red remote control transmitter, as
Figure 3 defines:
Figure 3: Infrared Remote Control
Transmitter
Turn input standard and output
resolution information display ON or
OFF
Select the composite video input
Select the component video input
Select the input PC to loop-through
Set the output resolution to 640x480
Set the output resolution to 800x600
Set the output resolution to
1024x768
Set the output resolution to
1280x1024
Set the output resolution to
852x480p
Set the output resolution to
852x576p
Set the output resolution to
1280x720p
Set the output resolution to
1920x1080i
Select the standard, normal (4:3) or
the wide (16:9) aspect ratio
Press and hold for 2 seconds to
reset all the ProcAmp settings
(contrast, brightness and so on)
In some versions, you need to be
within the PICTURE menu to do this
Turn the 3D enhance feature ON or
OFF
Turn the digital noise reduction
feature ON or OFF
Press to accept changes and to
change SETUP parameters
Press to adjust the picture
parameters
MENU
NR
PC
YPbCr
S-VIDEO
C-VIDEO
3D
PICTURE
RESET
ASPECT
SXGA
SVGA
VGA XGA
576p 720p 1080i
480p
ENTER
To Next Page
Loading...
Need help?
General
