Kramer VP-440X

VP-440X Quick Start
P/N:
2900- 30123 3 QS
Rev:
3
Scan for full manual
VP-440X Quick Start Guide
This guide helps you install and use your VP-440X for the first time.
Go to www.kramerav.com/downloads/VP-440X to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VP-440X 4K Presentation Switcher Scaler
1 Quick start guide
1 Power adapter and cord
4 Rubber feet
Step 2: Get to know your VP-440X
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
#
Feature
Function
1
48 V () Slide Switch
Slide up (48V) to select a condenser type microphone; slide down to select a dynamic
type microphone (we recommend that you slide down if a microphone is not connected to
the VP-440X).
2
MIC 6.3mm Jack
Connect to the microphone source.
3
Input Selector
Buttons
HDMI IN
Press to select the HDMI input (from 1 to 4).
4
PC IN
Press to select the computer graphics input.
5
MENU Button
Displays the OSD menu.
6
Navigation
Buttons

Press to decrease numerical values or select from several definitions.
When not in the OSD menu, press to reduce the output volume.

Press to move up the menu list values.

Press to increase numerical values or select from several definitions.
When not in the OSD menu, press to increase the output volume.

Press to move down the menu list.
ENTER
Press to accept changes and change the SETUP parameters.
7
RESET TO XGA/1080p Button
Press and hold for about 5 seconds to toggle the output resolution between XGA and
1080p, alternatively.
8
PANEL LOCK Button
Press and hold for about 5 seconds to lock/unlock the front panel buttons.