VS-42H2 Quick Start (P/N: 2900-300947QS REV 1)
P/N:
Rev:
Scan for full manual
VS-42H2 Quick Start Guide
This guide helps you install and use your VS-42H2.
Go to www.kramerav.com/manual/VS-42H2 to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check What’s in the Box
4x2 HDMI Matrix Switcher
4 Rubber feet Infrared remote control transmitter
1 Power supply (5V DC)
1 Quick start guide
Step 2: Get to know your VS-42H2
# Feature Function
Lights yellow when receiving an IR signal.
2 IR Sensor Receives signals from the infrared remote control transmitter.
Lights green when the device is powered on.
4
INPUT SELECTOR
Press one of the four inputs to switch it to OUT 1.
5
INPUT SELECTOR
Press one of the four inputs to switch it to OUT 2.
6 MUTE OUT 2 Button Press to toggle mute of the OUT 2 signal.
Press to toggle mute of the OUT 1 signal.
8 EDID Button Press to capture the EDID (see Step 6).
Press and hold to lock the front panel buttons. Press and hold again to unlock.
To Next Page
Need help?
General
