Kramer VS-44H2A - Quick Start Guide Manual

VS-44H2A Quick Start
P/N:
2900- 301078QS
Rev:
2
Scan for full manual
VS-44H2A Quick Start Guide
This guide helps you install and use your VS-44H2A for the first time.
Go to www.kramerav.com/downloads/VS-44H2A
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VS-44H2A 4K HDMI 4x4 Matrix Switcher
1 Set of rack ears
4 Rubber feet
Remote control transmitter with batteries
1 Power cord
1 Quick start guide
Step 2: Get to know your VS-44H2A
# Feature Function
1
IR Sensor
Receives signals from the infrared remote-control transmitter.
IR LED
Lights yellow when receiving an IR signal.
2
ALL Button Press followed by an input button to connect the selected input to all outputs.
For example, press ALL and then Input button # 2 to connect input # 2 to all the outputs.
3
OFF Button
Press after pressing an output button to disconnect the selected output from the inputs.
To disconnect all the outputs, press ALL followed by OFF.
4 IN Select Buttons (1 to 4) Press to select the input to switch after selecting an output (also used for storing machine
setups).
5
OUT Select Buttons (1 to 4)
Press to select an output to switch followed by an input.
6
STO Button
Press STO followed by an INPUT (1 to 4) button to store the current switching
configuration to the location corresponding to that INPUT number.
7 RCL Button Press RCL followed by the corresponding INPUT (1 to 4) button to recall the preset
switching configuration saved in that location.
8
LOCK Button
Press and hold to toggle the locking/release of the front panel buttons.
9
EDID Button
Press EDID + STO buttons to enter the EDID mode.
10
OUTPUT/INPUT 7-segment LED
Display
Displays the input currently switched to the output which is marked above each input.