Step 5: Operate via the front panel buttons and via the:
WWW.KRAMERAV.COM
IR Remote Embedded Web Page
Step 4: Connect the power
Connect AC power to the rear of the switch on its power and then switch on
the power on each device.
VS-62HA,
RS-232 and Ethernet
Protocol 3000 (Default) Legacy
Baud Rate: 115,200 9,600
Data Bits: 8 8
Stop Bits: 1 1
Parity: None None
Command Format: ASCII ASCII
Example (Set display mode to Picture in Picture): #Y 0,110,1<CR> >Y 0 110 1<CR>
To reset the IP settings to the factory reset values, power cycle the device while holding in the Ethernet Reset button, located on the
rear panel of the unit
IP Address: 192.168.1.39
Subnet mask: 255.255.000.000
Default gateway: 000.000.000.000
TCP Port #: 5000
UDP Port #: 50000
Maximum UDP Ports: 10
Maximum TCP Ports: 4
Web page password 1234
Front panel buttons Turn power off. Turn power on again while holding the RESET TO XGA/720p front panel button.
The LEDs blink. Full factory reset is complete once the LEDs cease to blink and react normally.
Note that Full Factory reset includes Ethernet reset as well
OSD Factory Reset through the Misc menu item
Web pages Factory reset via the Device Settings embedded Web page
Protocol 3000 Use “Factory” command or #Y 0,771,1<CR>
To Previous Page
Loading...
