EasyManuals Logo

Kramer VS-88HDxl Quick Start Guide

Kramer VS-88HDxl
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
VS-88HDxl Quick Start
P/N:
2900- 30125 6 QS
Rev:
2
Scan for full manual
VS-88HDxl Quick Start Guide
This guide helps you install and use your VS-88HDxl for the first time.
Go to www.kramerav.com/downloads/VS-88HDxl to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VS-88HDxl 8x8 3G SD/HD-SDI Matrix Switcher
1 Set of rack ears
4 Rubber feet
RC-IR3 IR remote control transmitter
1 Power cord
1 Quick start guide
Step 2: Get to know your VS-88HDxl
#
Feature
Function
1
IR Receiver
Receives signals from the IR remote control transmitter. Lights yellow when receiving
signals.
2
POWER LED
Lights when the unit is ON.
3
ALL Button
Press ALL and then press an IN button to connect the selected input to all outputs.
4
OFF Button
Press OFF + OUT to disconnect the selected output from the inputs.
Press OFF + ALL to disconnect all outputs.
Press and hold OFF to toggle between dual link and normal mode.
5
IN SELECT Buttons
Press to select the input to switch to the output.
Press and hold buttons IN1 to IN5 to change the genlock timing (see Step 4)
6
OUT SELECT Buttons
Press to select the output to which the input is switched.
7
STO (STORE) Button
Press STO and then press an IN/OUT SELECT key to store the current setting.
8
RCL (RECALL) Button
Press RCL and the relevant IN/OUT SELECT key to recall a setup from the non-volatile
memory.
9
LOCK Button
Press and hold for three seconds to disable/enable the front panel buttons.
10
TAKE Button
Press to confirm a command in Confirm mode (see Step 6).
11
7-segment INPUT Display
Displays each input under the output number that it is switched to.
12
GENLOCK BNC Connector
Connect to the genlock source.
13
TERM HI-Z/75Ω Pushbutton
Press to terminate the genlock source (75Ω) or release for looping.
14
LOOP BNC Connector
Connect to the genlock connector of the next unit in the line.
15
INPUT BNC Connectors
Connect to the serial digital video sources.
16
RS-232 9-pin D-sub (F) Port
Connect to a PC or a control device.

Other manuals for Kramer VS-88HDxl

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kramer VS-88HDxl and is the answer not in the manual?

Kramer VS-88HDxl Specifications

General IconGeneral
BrandKramer
ModelVS-88HDxl
CategoryMatrix Switcher
LanguageEnglish

Related product manuals