14
Functional details
Motor overload protection
The motor is protected against overloading by means of an overload protection
device included in the motor coil. In the event of overloading or jamming, the
excess temperature cut-out serves to switch o the motor. In case of repeated
switching o the motor by means of the excess temperature cut-out, make sure
to eliminate the cause of the failure.
Replacements and inspection work should only be performed by qualified
persons when the machine is disconnected from the power supply, i.e.
with plug pulled out from the electrical socket.
High pressure hose and spray device
The high pressure hose and spray device which are part of the K 1050 TS T equipment,
are made of high quality material and engineered to conform with the operating
conditions of the high pressure cleaner and are duly labeled.
If replacement parts are required, only such parts that are authorized
by the manufacturer may be used. The warranty is automatically void
if spare parts of third-party providers are used! The high pressure hose
and spray device must be connected in a pressure-tight manner
(without leakage).
The high pressure hose may not be driven over, pulled excessively, or
twisted. The hose may under no circumstances be pulled over sharp edges.
Defective high pressure hoses must not be repaired (acc. to DIN 20022) but
have to be replaced by new hoses approved by the manufacturer.
To Next Page
Loading...
Need help?
General
