17
Putting into operation
10. Check water inlet filter for cleanliness
prior to putting the machine into
operation. When inside filter is
contaminated, remove filter and follow
step 10.1.
11. Connect water hose to water inlet.
The cleaner may be connected to a
water mains (1-10 bar pre-pressure)
with either cold or hot water
(up to 60°C).
Check sieve for damages.
Do not operate high pressure without or with a damaged sieve.
10.1 If contaminated, remove sieve and
thoroughly rinse and clean with the
rest of the parts in clear water.
Be careful when using hot water!
When running your high pressure cleaner with hot water of 60° C raised
temperatures occur. Do not touch the metal parts of the cleaner without
safety gloves!
To Next Page
Loading...
Need help?
General
