18
Then straighten a
paper clip ...
and release the
injector with an
open-ended
spanner
Remove the injector
together with the
spring and return
valve.
and check that
it is clean.
Reconnect the hose,
and you are
ready to continue
your work!
and replace the
return valve.
The injector may be dirty and
you
should
first
remove
the hose!
Now turn on the water and
you should get a powerful
stream of water
But if you only
get a weak flow
Clean the injector
thoroughly from both sides
The pressure gauge shows a 10% higher pressure than the working pres
You only get a weak flow of water or no water at all!
Small repairs -Small repairs -
Small repairs -Small repairs -
Small repairs -
To Next Page
Loading...
Need help?
General
