Kranzle K 145 T - Troubleshooting: Weak Water Flow

18
The pressure gauge shows a 10% higher pressure than the working pressure.
You only get a weak flow of water or no water at all!
The injector
may be dirty
and you
should first
remove the hose!
Now turn on the water and
you should get a powerful
stream of water
But if you only
get a weak flow
Then straighten
a paper clip ...
... release feed
line and injector
with an open
ended
spanner
...,
... and pull out
the injector!
Clean the injector
thoroughly from both sides
...
and check that
it is clean.
Reconnect
the hose ...
and you are
ready to continue
your
work!
Small repairs -
Reconnect
feed line
and injector.