Kranzle K 1622 TS User Manual

20 21
11. Switch on high-pressure cleaner with
opened safety trigger gun. Bleeding
of the high-pressure cleaner: Pull and
release trigger of safety trigger gun
several times. Start cleaning task.
10. Connect to circuit (see technical data).
Do not touch the mains plug or any live parts with wet or moist hands.
12. When using the dirtkiller lance make
sure that lance points downward when
starting.
13. Adjust operating pressureinfinitely
using the rotary handle. The maximum
pressure is factory-set.
7. Check water inlet filter for cleanliness
prior to putting the high-pressure
cleaner into operation.
Manually unscrew plug-in coupling.
Take out the water inlet filter using
needle nose pliers and thoroughly
rinse it with clear water and clean
it with the other parts. If the sieve is
dirty, water can not get through and
pressure will not build up.
8. Connect water hose to water inlet
(mi-
nimum requirements; 5 m hose length,
cross-section ¾", 10 bar). The high -pres-
sure cleaner may be connected to a
water mains (1-10 bar pre-pressure) with
either cold or hot water (up to 60 °C).
The K 1622 TS provides the oppor tunity
of sucking in water out of a container
(see direct suction).
Check the water inlet sieve for damage. Do not operate the
high-pressure cleaner without or with a damaged filter.
Be careful when using hot water!
When running your high-pressure cleaner with hot water of 60 °C raised
temperatures occur. Do not touch the metal parts of the high-pressure
cleaner without safety gloves!
9. Each time check oil level of the
oil sight glass prior to putting the
high-pressure cleaner into operation.
Oil level must be visible in the middle
of the oil sight glass.
Putting into operation Putting into operation

Kranzle K 1622 TS Specifications

General

Brand	Kranzle
Model	K 1622 TS
Category	Pressure Washer
Language	English