12 13
General rules
Oil change
The first oil change should be carried out
after approximately 50 operating hours,
then every year or after 250 operating
hours. If the oil turns grey or white, you
must change the oil. In case of exchan-
ging oil being required, the oil drain screw
must be opened above a container and the
high-pressure cleaner be emptied. The oil
is to be caught in the reservoir and disposed
of in an approved manner.
Oil leakage
If oil leaks contact your nearest after-sales service (dealer) at once.
Failure to observe this instruction may cause damage to the environment
and/or transmission gearbox.
In case of increased humidity or fluctuations in temperature
development of condensed water is possible. If the oil turns
grey or white, you must change it.
New oil: 0.25 l
Kränzle High Performance Gear Oil
(Item no.: 400932)
General rules
Intended use
This high-pressure cleaner is to be used solely for high-pressure water jet cleaning
applications without detergents or low-pressure cleaning work with detergents
(e.g. with a foam injector or washing brush).
Environmental, refuse disposal and water protection regulations
must be observed!
Inspections
The high-pressure cleaner must be inspected according to the “Guidelines
for Liquid Spray Devices” at least once every 12 months by a qualified person,
to ensure that continued safe operation is guaranteed. The results of the
inspection are to be recorded in writing (see Inspection reports).
High-pressure cleaners used for commercial purposes have
to be checked by a qualified person at least every 12 months!
Accident prevention
The high-pressure cleaner is designed for accidents to be impossible if used
correctly. The user is to be notified of the risk of injury from hot machine parts
and the high-pressure jet. The “Guidelines for Liquid Spray Devices” must be
complied with.
To Next Page
Loading...
Need help?
General
