Kranzle K 1622 TS User Manual

18 19
2. Unwind high-pressure hose straight
and without nooses. (When using high-
pressure hose extensions take care that
the max. length of 20 m is not exceeded!)
The high-pressure hose may leave signs
of abrasion on some floors. Alternatively,
please also find non-marking high-
pressure hoses in our range.
3. Plug screw high-pressure hose included
in scope of delivery at pump outlet and
tightly screw pressure-tight.
4. Tightly screw together high-pressure
hose and safety trigger gun.
6. Screw together lance and
safety trigger gun pressure tightly.
5. Lance on to safety trigger gun.
Do not place the K 1622 TS on rough surface because the high-pressure
cleaner tends to vibrate during operation.
When carrying the K 1622 TS, make sure to bear in mind the weight of
the high-pressure cleaner (see technical data).
It is imperative that safety instructions be observed during use of
the high-pressure cleaner.
Neither set up or operate the K 1622 TS in rooms where there is a risk of
fire or explosion nor put it into puddles. Do not use the high-pressure
cleaner under water. If, none the less, the high-pressure cleaner is ope-
rated in a hazardous area, the applicable safety regulations are to be
observed.
1. Carry the K 1622 TS to its their place of
use and ensure secure footing of the
high-pressure cleaner.
Putting into operation Putting into operation
Accessories may only be connected to a Kränzle-approved trigger gun
with safety catch.
High-pressure hose and spray device
The high-pressure hose and spray device which are part of the K 1622 TS equipment,
are made of high quality material and engineered to conform with the operating
conditions of the high-pressure cleaner and are duly labeled.
If replacement parts are required, only such parts that are authorized
by the manufacturer may be used. The warranty is automatically void if
spare parts of third-party providers are used! The high-pressure hose and
spray device must be connected in a pressure-tight manner (without leakage).
The high-pressure hose may not be driven over, pulled excessively, or
twisted. The high-pressure hose may under no circumstances be pulled
over sharp edges. Defective high-pressure hoses must not be repaired
(acc. to DIN 20022) but have to be replaced by new hoses approved by
the manufacturer.

Kranzle K 1622 TS Specifications

General

Brand	Kranzle
Model	K 1622 TS
Category	Pressure Washer
Language	English