When running your high pressure cleaner with hot water of
140 °F raised temperatures occur.
Do not touch the pump without safety gloves!
This is accomplished by turning the
handwheel. The default setting is
maximum pressure.
Adjusting the pressure
Preparation for use
1. Switch off the machine.
2. Cut off the water supply.
3. Open the spray gun briey
until the pressure is released.
4. Apply the safety catch on the spray gun.
5. Remove the water hose and spray gun.
6. Drain the pump: switch on the motor for approx. 20 seconds.
7. Pull the plug from the socket.
8. Winter: store the pump in rooms above 0°C.
9. Clean the water lter.
To shut down the pump:
To Next Page
Loading...
Need help?
General
