3
Prior to Installation:
· Make sure you have all necessary parts by checking the diagram and parts list. If any
part is missing or damaged, please contact Kraus Customer Service at 800-775-0703
for a replacement.
· Read all instructions and safety warnings and ensure you have all tools, parts, and
equipment necessary for a safe installation.
· Turn off the hot and cold water supply at the angle stops and turn on the old faucet
to release any built up pressure. Remove existing faucet. Clean sink or countertop to
remove any debris, plumber’s putty, or silicone.
· Flush angle stops to release any debris prior to installation.
· Pre-drilled hole size requirement: 1 3/8" (min)
· Max countertop thickness: 2 1/2”
· 1, 2 or 3 hole installation with optional deck plate (sold separately)
Tools Required
Adjustable Wrench Phillips Screwdriver
Safety Goggles
Pipe Tape
Silicone Sealant
STOP
R
Care & Maintenance
To keep the product clean & shining, follow the steps below:
1. Rinse with clean water & dry with a soft cloth
2. Do not clean with soaps, acid, polish, abrasives or harsh cleaners
3. Do not use cloth with a coarse surface
4. Unscrew the aerator and clean when necessary
This installation manual is subject to change without further notice.
ACID
To Next Page
Loading...
Need help?
General
