11
Leakage under the
handle
Locking nut has
come loose
Trouble - Shooting
PROBLEM CAUSE ACTION
Water will not shut off
completely
Cartridge may be
defective
Leaking between spray
head and the hose
Spray head may be
loose or washer is
not seated correctly
in the hose
connection
Remove the index button
at the top of the handle.
Loosen set screw with a hex
wrench. Remove the handle
and unscrew trim cap by
hand. Tighten locking nut
with an adjustable wrench
Remove the index button
at the top of the handle.
Loosen set screw with a hex
wrench. Remove the handle
and unscrew trim cap by
hand. Unscrew the locking
nut with an adjustable
wrench. Remove ceramic
disc cartridge. Check for
cracks
Tighten the spray head
by hand until snug. Make
sure the washer is seated
correctly
If you have followed the instructions carefully and your faucet still
does not work properly, take the following corrective steps:
Care & Maintenance
*To keep the product clean & shining, follow the steps below:
1. Rinse with clean water & dry with a soft cloth
2. Do not clean with soaps, acid, polish, abrasives, or harsh cleaners
3. Do not use cloth with a coarse surface
4. Unscrew the aerator and clean when necessary
*This installation manual is subject to change without further notice.
To Next Page
Loading...
Need help?
General
