EasyManuals Logo

Kraus Oletto KPF-2620 Installation Guide

Kraus Oletto KPF-2620
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
9
Step 6: Flush faucet
Pull the hose assembly out of the spout and
remove the spray head (A) by unscrewing it
from the hose in a counterclockwise
direction. Be sure to hold the end of the hose
down into the sink and turn the faucet on to
the warm position where it mixes hot and
cold water. Flush the water lines for one
minute. This ushes away any debris that
could cause damage to internal parts. Check
for leaks. Re-tighten any connections if
necessary, but do not overtighten. Reinstall
the spray head (A) by hand tightening it
back onto the sprayer hose.
After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
NOTE: Please make sure washer is
installed attaching sprayer to hose.
A

Other manuals for Kraus Oletto KPF-2620

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kraus Oletto KPF-2620 and is the answer not in the manual?

Kraus Oletto KPF-2620 Specifications

General IconGeneral
BrandKraus
ModelOletto KPF-2620
CategoryPlumbing Product
LanguageEnglish

Related product manuals