11
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work
properly, take the following coorective steps:
Care & Maintenance
*To keep the product clean & shining, follow the steps below：
1. Rinse with clean water & dry with a soft cloth
2. Do not clean with soaps, acid, polish, abrasives, or harsh cleaners
3. Do not use cloth with a coarse surface
4. Unscrew the aerator and clean when necessary
*This installation manual is subject to change without further notice.
10
9
11
12
13
Hexagon Nut
Hot
Water
Cold
Water
Close
Open
Left
Hot Water
Push
25˚
90˚
PROBLEM CAUSE ACTION
Leakage under the
handle
Bonnet nut (9) has
come loose
Remove the cover button (12).
Loosen set screw (11) with hex
wrench (15). Remove the
handle (10). Unscrew cap (9)
(by
hand only). Tighten bonnet nut
(8) with an adjustable wrench
The aerator has an
irregular or reduced
water ow
The aerator is dirty or
mis-tted
Remove the aerator and
check for debris.
Ensure that the rubber
washer is properly installed
Water will not shut o
completely
Cartridge may need to
be adjusted or replaced
Remove the cover button (12).
Loosen set screw (11) with hex
wrench (15). Remove the
handle (10). Unscrew cap (9)
(by hand only). Tighten bonnet
nut (8) with an adjustable
wrench. Remove the cartridge
(7). Check for cracks
There is leaking from the
sink drain at the base of
the sink.
The sink has a rough or
irregular surface.
Apply additional silicone
sealant to the beveled side of
the drain ange. Retighten
and test for leaks
There is a low ow of
water.
The lter washer in the
hose connectors is dirty.
Turn o the water supply at
water valve and unscrew the
hose connectors from water
supply lines. Clean the lter
washer in the water lines with
hot water, removing any debris
or calcium build up
To Next Page
Loading...
Need help?
General
