3
Prior to Installation:
· Make sure you have all necessary parts by checking the diagram and
parts list. If any part is missing or damaged, please contact Kraus
Customer Service at 800-775-0703 for a replacement.
· Turn off the hot and cold water supply at the angle stops and turn on
the old faucet to release any built up pressure. Remove existing faucet.
Clean sink or countertop to remove any debris, plumber’s putty, or
silicone.
· Flush angle stops to release any debris prior to installation.
· Pre-drilled hole size requirement: 1 3/8" (min)
· Max countertop thickness: 1 3/4”
Tools Required
Adjustable Wrench Phillips Screwdriver
Safety Goggles
Pipe Tape
Silicone Sealant
To Next Page
Loading...
Need help?
General
