Step 5. Making the waterline connections
Step 6. Flushing and checking for leaks
Thread the nut (1) on the supply
line onto the outlet of the water
supply valve and tighten with a
wrench. Do not overtighten.
Pull the hose assembly out of the
spout and remove the spray head
by unscrewing it from the hose in
a counterclockwise direction. Be
sure to hold the end of the hose
down into the sink and turn the
faucet on to the warm position
where it mixes hot and cold water.
Flush the water lines for one
minute. This flushes away any
debris that could cause damage
to internal parts. Check for leaks.
Re-tighten any connections if
necessary, but do not overtighten.
Reinstall the spray head by hand
tightening it back onto the spray
hose. After installation is
completed, turn on the hot and
cold water supplies. Check for
leaks.
1
8
NOTE: Please make sure filter
washers are installed before
connecting to the main valve.
To Next Page
Loading...
Need help?
General
