continue
d
Menu Functions
AC Mains
This function enables you to operate the Evolution Two from a switched AC outlet.
If AC Mains is set to
ON, the preamplifier turns on immediately, by-passing stand-
by. Thereafter, you may switch the preamplifier to and from stand-by, using the
power button or pwr key (3). The options are:
OFF, ON.
Enter the menu, then:
1. Use the level control knob on the preamplifier chassis front panel or up and
down keys (16) on the remote control to select:
AC MAINS.
2. Press the enter button on the preamplifier chassis front panel or the enter key (18)
on the remote control
. The front panel display (15) shows the default mode: OFF.
3. Use the level control knob or the up and down keys to select the desired
option:
OFF or ON.
4. Press the enter button or key to confirm the selection. The front panel display
reads:
AC MAINS.
OFF
The Evolution Two switches to stand-by mode, when it detects AC power.
ON
The Evolution Two turns on immediately, bypassing the stand-by mode, when it
detects AC power.
Backlight
This function enables you to control the blue power indicator brightness. The
options ar
e:
OFF
, LOW (25%), MED (50%), HIGH (100%)
.
Enter the menu, then:
1. Use the level control knob on the preamplifier chassis front panel or up and
down keys (16) on the r
emote contr
ol to select:
BACKLIGHT
.
2. Pr
ess the enter button on the pr
eamplifier chassis front panel or the enter key
(18) on the remote control
. The front panel display (15) reads: BRIGHTNESS.
3. Pr
ess the enter button or the enter key again
. The fr
ont panel display shows
the default mode:
HIGH.
4. Use the level control knob or the up and down keys to select the desired
brightness:
OFF, LOW, MED, HIGH.
5. Press the enter button or key to confirm the selection. The front panel display
reads:
BRIGHTNESS.
33
To Next Page
Loading...
