Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER - RC-5 Control

43
8. Use the level control knob or up and down keys to scroll to: BACK.
9. Press the enter button or key to return to: TRIGGER 1.
10. Use the level control knob or the up and down keys to scroll to: TRIGGER 2.
11. Repeat Steps 3-7 to set Trigger 2.
ON
The 12 Volt trigger output is enabled at power on for the selected trigger (Trigger 1
or 2).
OFF
The 12 Volt trigger output is disabled at power on for the selected trigger (Trigger
1 or 2).
DELAY
The 12 volt trigger output is enabled at power on for the selected trigger (Trigger 1
or 2), and the delayed for a period of time (0-20 seconds).
RC-5 Control
This function enables you to change the link transmit status of the Evolution Two.
The options are:
LINK TRANSMIT, LINK RECEIVE.
Enter the menu, then:
1. Use the level control knob on the preamplifier chassis front panel or up and
down keys (16) on the remote control to select:
RC-5 CONTROL.
2. Press the enter button on the preamplifier chassis front panel or the enter key
(18) on the remote control
. The front panel display (15) shows the default
mode:
LINK TRANSMIT.
3. Use the level control knob or the up and down keys to select the desired
option:
LINK TRANSMIT or LINK RECEIVE.
4. Press the enter button or key to confirm the selection. The front panel display
reads:
RC-5 CONTROL.
The right-ter
minated pr
eamplifier channel is the link transmitter of RC-5 data.
Connect the RC-5 cable to the RC-5 connector on the right-terminated preampli-
fier channel. For more information on linked preamplifier channels, see
Appendix:
CAN Link and Multiple Evolution T
wo Pr
eamplifiers,
on page
5
1.
continue
d