Kress Robotik Mission KR113

Questions and Answers

M
Michael GrossAug 7, 2025
Why does my Kress Robotik Lawn Mower run outside the boundary wire?
- D
  Diane HornAug 7, 2025
  If your Kress Robotik Lawn Mower runs outside the boundary wire, doesn't mow within a zone, or reverses/rotates erratically, several factors could be at play. Ensure at least 1m spacing from other robotic mower boundary wires. Check for and smooth out any acute angles in your boundary wire installation. In wet conditions, inspect boundary wire joints and provide waterproof insulation. Repair any damaged boundary wire insulation with tape. Finally, if the cutting area exceeds MissionTM's capacity, decrease it.
R
Roberto Gaines MDAug 12, 2025
What to do if Kress Robotik Lawn Mower cannot dock with Charging base?
- E
  Edward NguyenAug 12, 2025
  If your Kress Robotik Lawn Mower cannot correctly dock with the charging base, try these steps: First, restart the mower. Second, clean the contact pins on both the charging base and the mower using a cloth to remove any debris.
S
Sarah MccormickAug 16, 2025
What to do if Kress Robotik Lawn Mower exits the boundary wire on a hill?
- C
  Christine DennisAug 17, 2025
  If your Kress Robotik Lawn Mower exits the boundary wire due to high speed on a hill, it's likely because the boundary wire is placed on a slope steeper than 17% (10°). Reposition the boundary wire away from these steep slopes.
P
Paul PerezAug 22, 2025
What to do if Kress Robotik Lawn Mower says “outside working area”?
- R
  Ross McphersonAug 22, 2025
  If your Kress Robotik Lawn Mower displays “outside working area” with a green LED while inside, the boundary wire ends are likely clamped incorrectly. Try reversing the boundary wire ends.
D
debrahernandezAug 27, 2025
Why is the green light flashing on my Kress Robotik Lawn Mower charging base?
- B
  bethjonesAug 27, 2025
  If the green light is flashing on the charging base of your Kress Robotik Lawn Mower, it indicates that the boundary wire isn’t connected. Ensure the boundary wire is correctly connected to the charging base and check for any breaks, especially at the wire ends.
R
Riley EatonAug 31, 2025
How to fix LED light on Kress Robotik Lawn Mower charging base not turning on?
- D
  Dawn HessSep 1, 2025
  If the LED light on the charging base of your Kress Robotik Lawn Mower doesn't turn on, the issue is likely due to a lack of power. Check that the charging base is properly connected to the charger, and that the charger is connected to a working power supply.