krispol STARCUS - Drive Reaction to Overload; Overload Function Activation; Overload Sensitivity Adjustment

16. ACTIVATION OF IMPULSE MODE
17. SWITCH CONFIGURATION
18. CHANGING THE SWITCH OPERATING MODES
Press the P2
programming button.
Press the P2
programming button.
Press the P2
programming button.
e roller shutter makes
short up/down movements.
e LED will flash once.
e roller shutter makes
short up/down movements.
e LED will flash once.
e roller shutter makes
short up/down movements.
e LED will flash once.
e roller shutter makes
short up/down movements.
e LED will flash once.
If the roller shutter makes short
up/down movements and the
LED flashes once - mode I has
been set.
If the roller shutter makes short
up/down movements and the
LED flashes twice - mode II
has been set.
If the roller shutter makes short
up/down movements and the
LED flashes three times - mode
III has been set.
If the roller shutter makes short
up/down movements and the LED
flashes four times - mode IV has
been set.
Press the
UP button.
Press the
DOWN button.
Press the
STOP button.
If the roller shutter makes short up/down movements,
the LED flashes once which means the impulse mode is on.
1. Activation of the impulse mode is possible after programming the end positions of the control unit.
2. When the impulse mode is on, the drive will make a short movement after pressing the direction
button on the remote control once.
e receiver can work in one of the four switch modes.
I MODE - ASTABLE SHUTTER SWITCH
A short press of the UP or DOWN button causes the roller shutter to move. Pressing the button
again stops the movement.
II MODE - STABLE SHUTTER SWITCH
Pressing the UP or DOWN button causes the roller shutter to move. Releasing the button stops the movement.
III MODE - ASTABLE SWITCH
A short press of the UP or DOWN button causes the roller shutter to move. Pressing the UP and DOWN
buttons simultaneously will stop the movement. In the impulse mode, a short press of the UP or DOWN
button causes a short movement of the roller shutter. Holding the UP or DOWN button for more than
2 seconds causes the roller shutter to move continuously; pressing the button again stops the movement.
IV MODE - IMPULSE SWITCH
In this mode, the switch works in step-by-step mode. Pressing the button causes the roller shutter
to move UP, pressing it again stops the roller shutter, and another pressing the button causes the roller
shutter to move DOWN.
A
A
x2
x2
x3
x3
x4
x4
Turn off the
power and turn
it on again.
Turn off the
power and turn
it on again.