krispol STARCUS - Comfort Position Management; Deleting Comfort Position; Percentage Function Control

Press the
DOWN button.
10. DELETING END POSITIONS
11. DELETING ONE TRANSMITTER
12. DELETING ALL TRANSMITTERS
Press the P2
programming button.
Press the P2
programming button.
e roller shutter makes short up/down
movements. e LED will flash once.
e roller shutter makes short up/down
movements. e LED will flash once.
End positions
have been
deleted
B remote
control has
been deleted
All transmitters
have been deleted.
e following procedure is to remove the end positions of the control unit together with the Comfort position.
e roller shutter makes two short
up/down movements. e LED will
flash three times.
x3
A
A A
B
B
Press the P2 programming
button on the A remote control.
Press the P2
programming button.
e roller shutter makes short
up/down movements. e LED
will flash once.
e roller shutter makes short up/down
movements. e LED will flash once.
e roller shutter makes two short up/down
movements. e LED will flash three times.
e roller shutter makes two short up/down
movements. e LED will flash three times.
e roller shutter makes short up/down
movements. e LED will flash once.
e roller shutter makes short
up/down movements. e LED
will flash once.
Press the P2 programming
button on the A remote control.
Press the P2 programming
button on the B remote control.
Press the P2
programming button.
x3
x3
Press the
STOP button.
e roller shutter makes short
up/down movements. e LED
will flash once.
Turn off the
power and
turn it on again.
Turn off the power
and turn it on again.
Turn off the power
and turn it on again.