Need help?Do you have a question about the KROHNE OPTISWIRL 4200 and is the answer not in the manual?
General| Type | Vortex flowmeter |
|---|---|
| Measurement Principle | Vortex shedding principle |
| Nominal Diameter | DN 15 to DN 300 |
| Suitable media | Liquids, gases, and steam |
| Process Connection | Flanged, threaded |
| Pressure Rating | PN 10, PN 16, PN 25, PN 40 |
| Output | 4-20 mA, pulse, frequency, or digital communication |
| Power supply | 24 V DC |
| Materials | Stainless steel |
| Protection Class | IP67 |
| Approvals | ATEX, IECEx |
Explains danger, warning, caution, and information symbols used in the manual.
Notes on proper installation, assembly, and adherence to safety directives.
User responsibility for suitability, intended use, and warranty implications.
Specifies intended application, suitable media, and rated flow velocities for the device.
Guidelines for storing the device and instructions for safe transportation.
Requirements for pipelines, prohibited installations, and placement relative to control valves.
Preferred mounting positions, minimum inlet/outlet sections, and flow straightener use.
General notes and step-by-step guides for sandwich and flange installation.
Instructions for mounting housings, heat insulation, and adjusting display orientation.
Safety precautions and wiring steps for the signal converter and its terminals.
Details on power requirements and connecting the 4-20 mA output signal.
Connecting external inputs and configuring binary output functions like limit switches.
How to connect and configure pulse, frequency, and status signal outputs.
Wiring for remote versions and essential grounding procedures for accuracy and safety.
Maintaining the device's IP rating through correct cable feedthrough installation.
To Next Page
