Operation
142
Pos: 48.75.10 / BA/Einstellunge n/Schneidwer k/Schnittlänge eins tellen/Schnittl änge Messer Bild @ 67\m od_130252832630 0_78.docx @ 617569 @ @ 1
Abb.
Pos: 48.75.11 / WHB/Warnhin weise - Allgem eingültig/VORSICHT - Zurückschl agende Mess er - nicht von Ha nd in Arbeitsp osition, Ha mmer verwenden, @ 55\mod_129 2578390301_ 78.docx @ 521 706 @ @ 1
CAUTION! - Blades fold back!
The blades are pre-tensioned via spring force. Risk of injury!
Never press the blades into working position manually.
• Use a tool, for example a hammer.
• Always wear protective gloves.
Pos: 48.75.12 / WHB/Warnhin weise - Allgem eingültig/VORSICHT - Verletzung sgefahr am Mes ser im Mess erbalken - Sch utzhandschuh e tragen @ 55\m od_129249 6039379_78.doc x @ 520211 @ @ 1
Caution! - Risk of injury
Risk of injury on the blade in the blade bar!
• Always wear protective gloves.
Pos: 48.75.13 / BA/Einstellunge n/Schneidw erk/Messer zusch alten CF/CV @ 6 7\mod_130 2529148221_78.d ocx @ 6175 97 @ @ 1
After turning on the blades, always check to see whether all the cutters have swivelled up.
If this is not the case:
• Move the blade control shafts (A/B) to the zero position of blades (turn both blade control
shafts (A/B) to position (-))
• Lower the conveyor floor mechanically or hydraulically
• Clean the cutter base and especially the cutter slots thoroughly
After cleaning:
• Set the desired chop length
After the blade control shafts (A/B) have been adjusted, the cutters automatically swivel back up
into working position.
If they have not, lightly tap any blades that have not already swivelled up with a tool (for
example a hammer) striking the back of the cutters to move them back to working position.
• Raise the cutter base.
Pos: 48.76 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
