Operation
51
Pos: 117.1 /Übersc hriften/Überschri ften 1/A-E/Bedienung @ 0\m od_1199789505403_7 8.docx @ 34825 @ 2 @ 1
10 Operation
Pos: 117.2 /Übersc hriften/Überschri ften 2/U-Z/Vor dem Mäheins atz @ 3\mod_12047883844 65_78.docx @ 73168 @ 2 @ 1
10.1 Before mowing
Pos: 117.3 /BA/Sic herheit/7. Gefahrenhin weise alt/Mähwerke/ Gefahr - Arbeitseinsa tz / Mähen @ 73\mod_13076959 72255_78.docx @ 654926 @ @ 1
DANGER! - Using the machine for work
Effect: Danger to life, injuries or damage to the machine.
• The glide skids must rest on the ground before start-up and during work
• Maintain an adequate safety distance from the cutting tools during operation
• There is danger of foreign objects being forcibly ejected even when the machine is
operated properly. Persons must therefore be directed out of the danger zone of the
machine.
• Special care should be taken when working near roads and buildings)
Pos: 117.4 /BA/Bedienun g /EasyCut/Mähen/ Mähen EC B 1000 / B 870 @ 100\mod_13303 55620077_78.docx @ 8928 30 @ 2 @ 1
10.2 Mowing
• Swivel parking supports into transport position.
• Move the machine to the working position.
• Block the rear power lift.
• Fold down the safety device.
• Set the lateral guides correctly.
• Before switching on the PTO make sure that the selected RPM and the direction of rotation
of the tractor PTO agrees with the direction of rotation of the machine and its permitted
maximum RPM.
• Before driving into the crop engage the tractor PTO in neutral gear and slowly bring it up to
the nominal machine RPM.
• Drive into the crop.
• Check the mowing unit suspension during mowing.
• To ensure a clean cut, adjust the driving and cutting speeds to the prevailing conditions (soil
condition, state of the crop, height, density).
Pos: 117.5 /BA/Bedienun g /EasyCut/Tripel/ Arbeiten nur mit Front mähwerk B 870 @ 225\mod_13926 26412640_78.docx @ 1821 939 @ @ 1
The front mowing unit alone can be used to mow small parcels of crop or narrow sections in
open fields. In doing so, the lateral mowing units must be located in the transport position.
Pos: 117.6 /BA/Bedienun g /EasyCut/Hinwei s Beim Mähen Steuerventi l schwimmstellung/se nken @ 9\mod_122088141239 1_78.docx @ 128661 @ @ 1
Note! - While mowing
Effect: Proper use of the machine
• Leave control unit(s) in the "Lower" or "Float position" position for work.
Pos: 117.7 /Layout Modu le /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
