Use and maintenance / SERIE EA 80xx
KRUPS Espresseria Automatic
33
DEUTSCH
ENGLISH
FRANCAIS
NEDERLANDS
DANSK
SVENSKA
NORSK
SUOMI
ITALIANO
Problem Probable causes Corrective actions
The coffee does not
come out of the cof-
fee tube (20).
The tube is blocked.
Unblock the tube with the clea-
ning wire or a toothpick.
The coffee grinder
makes a strange
noise.
Foreign particles are inside the grin-
der.
Contact KRUPS Customer
Service.
The grinder setting
button (13) is diffi-
cult to turn.
Has the grinder setting button been
moved when grinding was not taking
place ?
Only turn the setting button
during grinding.
No steam comes
out of the steam
nozzle (21).
The nozzle or the nozzle support is
blocked.
Remove the steam nozzle
from its support and unblock
these two parts using the clea-
ning wire.
Temporarily remove the Claris
cartridge.
There is not enough
frothed milk.
Check that steam is coming out of
the nozzle.
Check if the small air inlet in the
upper part of the nozzle is blocked.
The recipient and milk are not cold
enough.
The milk is not fresh enough.
Unblock the steam nozzle with
the cleaning wire.
Unblock the inlet, dry it and if
necessary rinse it with water.
Make sure the recipient and
milk are cold before frothing.
We recommend using very
fresh pasteurised or UHT milk.
The frothed milk is
not thick enough.
Check if the two ends of the small
stainless steel tube are connected to
the steam nozzle.
Correct the position of the
stainless steel tube.
The auto-cappuc-
cino accessory (op-
tional) does not
suck up the milk.
Check that the accessories are
connected correctly to one another
and that they are not blocked.
Connect the accessories cor-
rectly to one another and un-
block them if needed.
After filling the water
tank (10), the war-
ning message re-
mains displayed on
the screen.
The water tank is not fitted correctly.
The float at the bottom of the tank
does not move freely.
The water tank is scaled.
Fit the water tank correctly.
Rinse the water tank under
water and descale if required.
The cleaning or des-
caling programme
will not start.
Programme error.
Unplug the appliance then
plug it back in and switch it on.
Restart the programme.
Falcon Display Tu?v 0827932:Mise en page 1 10/03/08 13:51 Page 33
To Next Page
Loading...
Need help?
General
