Krups EA871 - Page 28

30
PROBLEM CORRECTIVE ACTIONS
Drinks
The coee is owing too slowly. Turn the “neness of grinding” button to the right to obtain a coarser
ground coee (this may depend on the type of coee used).
Perform one or several rinsing cycles.
Change the Claris Aqua Filter System cartridge.
The coee is too light or not full-
bodied enough.
Avoid the use of oily, caramelised or avoured coees.
Check that the bean container contains coee and that it is moving
down correctly.
Decrease the volume of the preparation and increase the strength of
the preparation using the coee strength function.
Turn the “neness of grinding” button to obtain a ner ground coee.
Make your drink in two cycles using the 2-cup function.
The espresso or the coee is not
hot enough.
Perform a coee rinsing circuit before you start to make your coee.
Increase the temperature of the coee in the machine's settings.
Heat the cup in the rinsing with hot water before starting to prepare
the drink.
Clear water is running from
the coee nozzles before each
coee.
As part of the pre-brewing process, water can come out of the coee
nozzles.
If one of the problems outlined in the table persists, contact the KRUPS Consumer Service.
Caution:
Manufacturer:
SAS GSM
Rue Saint-Léonard F-53104 Mayenne
France