EasyManuals Logo

Krups EA9010 Service Manual

Krups EA9010
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
DE
FRNL
IT
EN
43
ENGLISH
KRUPS SERIE EA9000
42
3
n Open the ground coffee funnel lid.
n Remove the ground coffee funnel.
n Clean the ground coffee funnel. You can clean it with the brush or under
running water. Caution: Dry it thoroughly. It must be dry when you replace
it.
4
n Put the funnel back without closing the lid.
5
n Put the cleaning table into the funnel.
n Close the funnel lid. You must run this programme right to the end. The
funnel is locked.
n Press the OK button on the screen.
6
n Place a recipient with a capacity of at least 0.6 litres under the coffee
nozzles and press OK.
n Follow the instructions on the screen. Once the cleaning cycle is complete,
empty the recipient and put it back under the coffee nozzles and fill the
tank again with water. After the second rinsing, empty the recipient and
the drip trays.
Caution: Make sure that the cleaning programme is completely finished.
If the cleaning programme is interrupted by a power cut or accidental unplugging of the ma-
chine, it must be started again from the beginning. A new cleaning tablet will be required in
this case. The programme must be started again completely in order to rinse the water cir-
cuit and eliminate any traces of harmful cleaning products.
!
n Automatic descaling programme of the steam circuit
A message on the screen will indicate when a descaling programme needs to be run for the
appliance. The frequency of this programme depends on the quality of the water used (the harder
the water, the more often the appliance has to be descaled) and on whether a Claris Aqua Filter
System filter is used or not. To run the descaling programme, you will need a recipient with a capacity
of at least 0.6 litres that may be placed underneath the coffee nozzles and the steam nozzle, and a
KRUPS descaling sachet (F 054 – a 40 g sachet is supplied in the Welcome Pack). The automatic
descaling programme has three phases: one descaling cycle and two rinsing cycles. The programme
lasts approximately 22 minutes.
Caution: To respect the guarantee conditions, the cleaning cycle must be carried out when the
appliance requests you not to postpone it further.
!
Caution: You are not obliged to carry out the descaling programme immediately the appliance
requests it, but it must be carried out reasonably soon. Only use KRUPS descaler sachets
supplied in the Welcome Pack; otherwise the guarantee will not cover any material damage
caused by the use of other brands of sachets. Descaler sachets are available from your
KRUPS After-Sales Service Centre.
!
1
n When the machine requests descaling, confirm to start the
programme.
n Empty the used coffee collector, take out and empty the drip trays.
2
n Remove the water tank.
n If you use the Krups Claris Aqua Filter System filter cartridge, remove
it before the descaling operation.
n Empty the water tank and then fill it with water up to the CALC mark.
n Pour the descaler into the water tank and put it back.
n Use a large spoon with a long handle to mix the water in the tank or
remove the water tank and carefully shake it from left to right until
the descaler is fully dissolved.
h
h

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Krups EA9010 and is the answer not in the manual?

Krups EA9010 Specifications

General IconGeneral
Milk FrotherYes
Adjustable Coffee StrengthYes
Adjustable TemperatureYes
Pump Pressure15 bar
Automatic ProgramsYes
Power1450 watts
ColorBlack
MaterialStainless Steel
Coffee TypeCoffee
Water Tank Capacity1.7 L
Bean Hopper Capacity250 grams
GrinderYes, Integrated
Special FeaturesOne-Touch Cappuccino, Automatic Cleaning

Related product manuals