Replace the water tank.
The light will go off
and the ‘calc’ light
become solid.
1 – Descaling cycle
The "calc" light will become solid. The descaling cycle will have started and will be run automatically. Water is pumped inter-
mittently to be expelled by the coffee nozzle and then the steam nozzle.
14
ENGLISHFRANÇAISESPAÑOL
DESCALING PROGRAM – TOTAL DURATION: ABOUT 22 MINUTES.
The quantity of scale deposited depends on the hardness of the water used. The machine will automatically warn
you by the ‘calc’ light coming on when you need to proceed with descaling. This program is available only when
the appliance requests it.
Caution! To benefit from the warranty conditions, it is essential to perform the machine descaling
cycle when informed to do so. Be sure to follow the procedure closely step by step.
You can continue to use the machine when the light is on, but you are advised to perform the program as soon as possible.
Press the ‘Service’ key
to start up the desca-
ling program.
The “calc”
and lights
will flash.
Place a container with a
minimum water capacity
of 0.6 l/20 oz under the
coffee outlets and
under the steam nozzle.
Remove and clean the
drip tray.
Empty the tank and fill
it with lukewarm water
up to the ‘calc’ mar-
king.
Dissolve a sachet of
Krups descaling
powder F054 (40 g).
Once you have
performed all these
operations, press the
‘Service’ key.
Only use Krups descaling products. You can obtain descaling products from Krups Service Centers.
Do not use conventional starchy sulphonic acid or other products containing acid.
The manufacturer may not be held responsible for damage to the machine through use of cleaners or descalers
not specifically recommended.
Empty your container
full of waste water.
Empty the drip tray and
re-insert. Place your
container again under
the coffee outlets and
steam nozzle.
Empty, clean and rinse
the water tank and
then fill it again up to
the max. level.
Replace your water
tank. The ‘calc’ light will
flash and the light
will go off.
2 – First rinsing
A first rinsing is needed to eliminate the remaining descaling agent.
This cycle is run automatically. It lasts about 6 minutes.
Press the ‘Service’ key.
The ‘calc’ light will
become solid. The cycle
will run automati-
cally and last about
6 minutes.
±±
10 mn
±±
6 mn
F054
If your product is equipped with our Claris-Aqua Filter System cartridge F088, please
remove this cartridge before the descaling operation.
When the cycle is
completed, the
and
‘calc’
flash.
Make certain to protect your work surface during descaling cycles, especially if they are made of marble,
stone or wood.
To Next Page
Loading...
Need help?
General
